xcp-ng 8 and 8.2 network speed problem
enes.selcuk last edited by enes.selcuk
xcp-ng 8 and 8.2 network speed problem "Cannot advertise speed 1000"
I tried to provide the solution in the link below, but after the server restarted, you lost network access. I rolled back the operations in the same way again. can you help me
# ethtool -s eth3 speed 1000 Cannot advertise speed 1000 Settings for eth3: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: Symmetric Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: Symmetric Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: 100Mb/s Duplex: Full Port: Twisted Pair PHYAD: 1 Transceiver: internal Auto-negotiation: on MDI-X: on (auto) Supports Wake-on: pumbg Wake-on: d Current message level: 0x00000007 (7) drv probe link Link detected: yes
enes.selcuk last edited by
ethtool -s eth3 autoneg off
ethtool -s eth3 duplex full
ethtool -s eth3 speed 1000
hello I did the above commands stuck at the last command network access is gone. Still did not respond. How can I solve if I need to wait command. The problem may be the cause. "ethtool -s eth3 speed 1000" I waited a long time for my article and access was gone.
Can't help with your issue, but wanted to point out that the article you linked only references Xenserver 6.X, so may not be applicable to newer versions.