PCIE pasthrough failure
-
Did a clean install. Loaded XOA. Then tried to enable all my PCIE through. Go to reboot and I see it start and about halfway through I get the black screen of death.
I am able to boot in safe mode, but can’t start XOA or anything of that sort.
VT-d Is enabled from bios.
Have zero clue how to get everything running again.
-
@davealex8 Are you trying to pass a PCIe device into your XOA system rather than a guest on your XCP-ng host?
-
Excuse my ignorance, but I am not sure? I have two NVME drives with one being used by XCPNG/XOA. I was on xen and clicked the PCIE pass through on the host, restarted, and then black screen. I am trying to pass through the other NVME controller so I can have a truenas VM but utilizing the other NVME drive. I didn’t want one big pool because if something happens I’m not reformatting the entire thing and loose the data.