Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Dell PERC H710 and SMART Warnings on Boot

1 Posts 1 Posters 270 Views 1 Watching

Log in to reply

F Offline

fluxtor
last edited by

Hi, probably a newbie question but we have a host using a Dell PERC Raid Controller with RAID 5 setup and we're getting the following warning on boot.

"smartd[848]: Device: /dev/bus/0 [megaraid_disk_xx] [SAT], no ATA CHECK POWER STATUS support, ignoring -n Directive"

Should I disable SMART on the RAID controller?
1 Reply Last reply
Reply Quote 0

Hello! It looks like you're interested in this conversation, but you don't have an account yet.

Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.

With your input, this post could be even better 💗

1 / 1