PCIE pasthrough failure
-
Did a clean install. Loaded XOA. Then tried to enable all my PCIE through. Go to reboot and I see it start and about halfway through I get the black screen of death.
I am able to boot in safe mode, but can’t start XOA or anything of that sort.
VT-d Is enabled from bios.
Have zero clue how to get everything running again.
-
@davealex8 Are you trying to pass a PCIe device into your XOA system rather than a guest on your XCP-ng host?
-
Excuse my ignorance, but I am not sure? I have two NVME drives with one being used by XCPNG/XOA. I was on xen and clicked the PCIE pass through on the host, restarted, and then black screen. I am trying to pass through the other NVME controller so I can have a truenas VM but utilizing the other NVME drive. I didn’t want one big pool because if something happens I’m not reformatting the entire thing and loose the data.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login