Host failure after patches
-
I maybe spoke to soon.
The host with my DR VM does not show as being part of the pool
Does I need to add it to the new pool master?
-
With a new pool master I am still unable to access the old pool slave as it reports the pool master is unavailable:
I expect this is because the pool slave is still looking for the old pool master and has not identified that a new pool master exists.
What needs to be done to the pool slave to have it appear as a member of the pool again?
-
-
No I didn't. Does this need to be run on the slave itself or the new master?
When you say "after selecting a new master" do you mean after I did this on the new master?
xe pool-emergency-transition-to-masterEdit:
Found this which shows this is run on the new pool master:
https://www.ervik.as/how-to-change-the-pool-master-in-a-xenserver-farm/ -
Yes you'd run that command on the pool master.
I linked this earlier in the thread, it outlines the process you need to follow:
https://docs.xenserver.com/en-us/xenserver/8/dr/machine-failures.htmlLet us know if this works!
-
Apologies, I missed that. I have run the command and now see:
hst103 is the new pool master. hst100 is the old pool master that failed.
In XO I can only see hst103 under hosts however all three hosts are listed under the pool:
-
@McHenry Have you tried restarting the toolstack on the hosts since running pool-recover-slave?
I have only had to do this once before but remember it going fairly smoothly at the time. (As smooth as you can expect a host failure to be anyways)
-
Have restarted the tool stack but no different.
When I view hst110 I see:
I was tempted to restart it however it has Patches pending installation after a restart and as the mater is not fully patched I thought best not to restart it. I understand the master needs to be patched first.
I just checked xsconsole on hst110 and it shill shows pool master unavailable
Do I need to change the pool master used by the slave?
-
@McHenry I am wondering if you are in a situation where you need to reboot. You have patches installed but have not rebooted, but have restarted tool stacks on the salves, which means some components have restarted and are running on their new versions? If you have support it may be best to reach out to Vates for guidance.
-
Can I restart the slave and install patches if the master has not been patched yet?
-
@McHenry No the pool master must always been patched and rebooted first. Do you have a pool metadata backup? Are your VMs on shared storage of some sort? In case you need to rebuild the pool.
-
My setup is pretty basic.
I have two hosts in the pool, one for running VMs on local storage and one for DR backups on local storage.
I'd like to setup shared storage so i could run the VMs on multiple hosts and seamlessly move them between hosts without migrating storage too.To setup shared storage would this be on an xcp-ng host or totally independent of xcp-ng?
-
All this complexity makes me question the advantages of having all hosts in the same pool.