Migrate from XenServer GuestTools to XCP-ng GuestTools

Chemikant784

Hello everyone

I'd like to get your opinion.

It's about migrating from Citrix GuestTools to XCP-ng GuestTools.

The VMs have driver updates enabled via Windows Update.

According to the instructions at https://docs.xcp-ng.org/vms/#fully-removing-xen-pv-drivers-with-xenclean, Windows driver updates should be disabled.

If this is done before XenClean, the IP configuration is lost in my tests because the network device switches from XenServer PV to the
emulated device.

The following procedure worked for me. The IP address was always retained. However, three reboots are required:

Create a VM snapshot
Uninstall Citrix XenServer Tools using a script (XenClean.ps1)
a. VM restarts automatically
Network check -> IP address correct
Shut down VM
Disable automatic driver updates for the VM via Windows Update
Restart VM
Network check -> IP address correct
Attempt to install XCP-ng drivers
a. Errors may occur because the vendor device might still be active. In this case, run XenClean.ps1 again to uninstall it.
b. Uninstall Citrix XenServer Tools using the script (XenClean.ps1)
i. VM restarts automatically
Network check -> IP address correct
Install XCP-ng Tools
Reboot when prompted
Network check -> IP address correct

Point 8 is critical. The XCP-ng GuestTools cannot be installed at this time because the vendor device for driver updates is still detected and has to be uninstalled first.

What do you think? Is there a better way, perhaps with only two reboots, while keeping the IP address the same?

I find it important to take over the IP address, as otherwise it temporarily reverts to DHCP, which can cause problems with the running server services.

I also tried disabling Windows Updates first and then running XenClean. However, XenClean doesn't then take over the original IP address of the XenServer PV adapter.

Thanks for your opinions or experiences.

dinhngtu

@Chemikant784 I've been preparing a reworked XenClean and XCP-ng driver onboarding tool here. Every time the onboard.ps1 script is run, it'll try to automatically uninstall old drivers and install the XCP-ng as conditions permit: https://nextcloud.vates.tech/index.php/s/eL4sfxQGxZXe8SX

The Windows Update device is quite stubborn since disabling it causes the problem as you said. Could you try the following procedure:

Keep the Windows Update option enabled
Block installation of the PCI\VEN_5853&DEV_C000 device using the "Prevent installation of devices that match any of these device IDs" setting
Run XenClean
Turn off the Windows Update option
Install XCP-ng drivers

Getting rid of the Windows Update device is quite cumbersome... I'll look for a way to automate this

Chemikant784

@dinhngtu Hi dinhngtu, thank you for your answer. I will try this out and report back later with any findings about this procedure.

Chemikant784

I've managed to test it as you suggested.

The IP address was retained throughout the entire process. But the installer of XCP-ng Tools still detects an incompatible device and asks to run XenClean again. The "Prevent installation of devices that match any of these device IDs" Policy was set as instructed.

This procedure has required four reboots. (1st XenClean, 2nd manual shutdown to disable Windows Update option, 3rd XenClean and 4th install XCP-ng tools)

Theoretically, there should be one final step to remove the PCI\VEN_5853&DEV_C000 device from the policy, just to avoid future problems.