XCP-ng
    • Categories
    • Recent
    • Tags
    • Popular
    • Users
    • Groups
    • Register
    • Login

    xcp-ng 8 and 8.2 network speed problem

    Compute
    2
    3
    548
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • enes.selcukE
      enes.selcuk
      last edited by enes.selcuk

      xcp-ng 8 and 8.2 network speed problem "Cannot advertise speed 1000"
      I tried to provide the solution in the link below, but after the server restarted, you lost network access. I rolled back the operations in the same way again. can you help me

      link

      # ethtool -s eth3 speed 1000
      Cannot advertise speed 1000
      
      Settings for eth3:
      	Supported ports: [ TP ]
      	Supported link modes:   10baseT/Half 10baseT/Full 
      	                        100baseT/Half 100baseT/Full 
      	                        1000baseT/Full 
      	Supported pause frame use: Symmetric
      	Supports auto-negotiation: Yes
      	Supported FEC modes: Not reported
      	Advertised link modes:  10baseT/Half 10baseT/Full 
      	                        100baseT/Half 100baseT/Full 
      	                        1000baseT/Full 
      	Advertised pause frame use: Symmetric
      	Advertised auto-negotiation: Yes
      	Advertised FEC modes: Not reported
      	Speed: 100Mb/s
      	Duplex: Full
      	Port: Twisted Pair
      	PHYAD: 1
      	Transceiver: internal
      	Auto-negotiation: on
      	MDI-X: on (auto)
      	Supports Wake-on: pumbg
      	Wake-on: d
      	Current message level: 0x00000007 (7)
      			       drv probe link
      	Link detected: yes
      
      enes.selcukE 1 Reply Last reply Reply Quote 0
      • enes.selcukE
        enes.selcuk @enes.selcuk
        last edited by

        ethtool -s eth3 autoneg off
        ethtool -s eth3 duplex full
        ethtool -s eth3 speed 1000

        hello I did the above commands stuck at the last command network access is gone. Still did not respond. How can I solve if I need to wait command. The problem may be the cause. "ethtool -s eth3 speed 1000" I waited a long time for my article and access was gone.

        1 Reply Last reply Reply Quote 0
        • DanpD
          Danp Top contributor 💪
          last edited by

          Can't help with your issue, but wanted to point out that the article you linked only references Xenserver 6.X, so may not be applicable to newer versions.

          1 Reply Last reply Reply Quote 0
          • First post
            Last post