@olivierlambert & @DustinB The issue was memory reserved for the integrated graphics card. I'm going to reduce the reserved memory to make more available for VMs and play around with it until I find the sweet spot. Thank you both for the help troubleshooting.

@olivierlambert Thanks for the help. I was able to check the bios at lunch and it is showing 16GB, but it did not have a memtest that I could find. I plan to run memtest86 this evening.

xl dmesg
xcp-ng_xl_dmesg.txt

dmesg
xcp-ng_dmesg.txt

@DustinB Thanks Dustin. I should have checked that already, but didn't even think about it... I'lll check it out when I get home this evening.

@olivierlambert Thanks for the response.

Here are two screen shots, from the vsconsole of the host and from the XO host page. The XO page shows XCP-ng using 1.59 GiB (I assume that is Dom0 usage). With no VMs running, the host is using 2.2GiB of 12GiB. I confirmed that both 8 GB sticks of ram were seated properly.

vsconsole

XO host page

I'm running xcp-ng on a Beelink EQR6 with a AMD Ryzen 5 6600H and 16GB ram. xcp-ng xsconsole (and XO) is only showing 12 GiB of Ram. Anyone have any ideas what is causing the reduction of ram?

Thx