XOA Error when installing
-
it now says 'success' after selecting 'guest tools' in the dvd drive section......is that what I was supposed to do??
-
is this the final thing that i should get???. How do i open the WEB UI ??
-
You should have an IP. Go to the HTTPS of this IP and you'll have the UI
-
I do not know the IP. may be it used dhcp to launch......now how to find the IP ???
-
-
did networking step....tried pinging the IP but failed......opening in browser failed too!
-
I have used bridged routing between XCP-ng VM and host. To the XOA VM in the XCP-ng server I gave IP from the subnet of the server i.e 192.168.0.x
-
Check your current XOA network config with
ifconfig -a
-
Wait, I don't understand. Where is running this XOA?
-
XOA virtual appliance is running in the xcp-ng center and xcp-ng center is running in vmware workstation.
-
From your current machine (where you post on this forum) I suppose you can ping your host, correct?
But you can't ping XOA VM?
-
Look under the VM's Networking tab to confirm the assigned IP address.
-
@olivierlambert @Danp seems like you are deep in helping Kilo lol. Should I make a new post?
-
@ZacApplegate No need. @olivierlambert Can you give feedback on his prior post?
-
Indeed i can ping xcp-ng host (192.168.0.55) from my pc .......
-
@Danp IP address is same 192.168.0.77 in the networking tab
-
no result of ifconfig -a.
-
@olivierlambert yes indeed
-
As sudoer, so with
sudo
before. -
@kilo at the shell prompt (as root user) type:
ip a l
you will see the IP if static of if DHCP worked.
if you need to configure the network edit (using vi or nano) /etc/network/interfaces
I show you mine as reference:# and how to activate them. For more information, see interfaces(5). source /etc/network/interfaces.d/* # The loopback network interface auto lo eth0 iface lo inet loopback # The primary network interface allow-hotplug eth0 iface eth0 inet static address 172.27.217.231 network 255.255.254.0 gateway 172.27.217.254
once the file is edited restart the network:
systemctl restart networking
note: remember to set auto on eth0 (see the line auto lo eth0)or when you give a network restart eth0 does not get the IP address and you need to reboot the VM.