vmware vm migration

acebmxer

Using XO-CE commit 2838b
esxi host 6.7.0 update 3

Following these steps - https://docs.xen-orchestra.com/v2v-migration-guide

Perform the first migration attempt
Start the V2V migration in Xen Orchestra, without enabling the Stop Source option.
This will transfer the VM data up to the snapshot named vm without tools.
tip
You can safely close your browser while the migration runs.

Monitor the migration progress using one of these methods:
Check the VM status in Xen Orchestra (it should show importing...).
Follow the disk transfer progress indicators.
Testing the migrated VM
Once the migration is complete:

Start the migrated VM copy on your XCP-ng environment.
tip
Use an isolated network to avoid IP conflicts.
The VM state might be slightly inconsistent since memory and cache data aren't fully synced.
Check the following during testing:
The VM boots up without issues.
Network connectivity is working properly.
Xen Tools installs and runs correctly.
Document any fixes or adjustments required to stabilize the VM.
Remove the test copy
Once you’ve finished your checks and taken notes, delete the test VM. This will free up resources and prevent any confusion before the final migration.

When I go to start the vm after first migration step i get the following error. I did set the wrong network for the vm and set to wrong SR. I can set that on final migration.

olivierlambert

Hi,

Can you please reformat a bit your post, because it's very hard to understand as you copy pasted stuff in the middle of your questions. Thanks!

florent

@acebmxer yes after the first migration, XO knwo that the migration is incomplete and that you may want to finish it later. But if you start this VM direvtly , it will write some data, thus it won't be in sync anymore with the Vmware snapshot. Then XO won't be able to resume

You can start a copy of the VM ( XO will handle it for you ) and delete the copy when you're done

My advice is to migrate this VM to the right SR and then do the resume. But keep in mind that the V2V tool is intended to target only one SR, so migrate all they disk to the same SR, and select the right one when resuming the V2V. You can change the network after