Restore only showing 1 VM

[ph7]

I have 2 jobs enabled and 4 disabled in Backup Overview
The 4 disabled are enabled in Sequences

[ph7]

A CR job (1 of the 2 enabled) ran and now I see all of them again

[MathieuRA]

@Team-XO-Backend Someone can take a look at it? I won't be to much available this week

[acebmxer]

I posted in the original thread that this issue only exists in this test branch. When i switched back to master branch all restore points were visable.

Edit - Just updated to 875ce and now back to single vm listed for restore... Commit bfb0a05 did not have issue.

Edit 2 - Updated to a6c50 and restore points are back again.

[Bastien Nollet]

@MathieuRA

I'll have a look

[ph7]

@Bastien-Nollet
I don't know, played around with it a little bit, all seemed to work, so I updated to master a6c50 as @acebmxer did and it still seems OK, so maybe we can put this on hold for now and put the energy on something else

[Bastien Nollet]

@ph7 Ok, let's do this.

If it happens again, can you check that XO can still access your remote on which missing VM backups are stored? (by using button "test your remote" on page settings > remote)

It may just me a network issue.

[ph7]

@Bastien-Nollet
It's a 1Gbit 4xHDD NFS where usually I get ~ 600 Mbit

Just a test to see how it looks when it's OK

[Bastien Nollet]

@ph7 Ok, thanks.

But the most important will be to do this test while some VMs are missing from the backup restore page (if it happens again)

[ph7]

@Bastien-Nollet said:

It may just me a network issue.

You may have a point there
My backup server is not at the same place as the host
and there may have been some other "heavy" traffic on anoter VLAN in that trunk between the switches.
@acebmxer How is it at Your place