Restore only showing 1 VM

[ph7]

I am on a test commit mra-fix-dashboard-reactivity

but have had this in earlier commits too:
In Backup/Restore (V5) I only see 1 VM
when I use the XO, suddenly the restore can sometimes see all VM's to restore.
I can not replicate this to see when I'm able to see all VM's or only 1.

Here is one example:

Rebooted XO
saw only 1 VM
started 2 older XO-CE, 9226c and 4bbfa to check, and I saw all the VM's
Looked in the "current" XO, and all the VM's where back
A CR job did run and now I only see 1 VM again.

I repeated this procedure but did only see 1

I'm not 100%, but I think it was OK in 5bdd7
It's possible it started here:
https://xcp-ng.org/forum/topic/11969/timestamp-lost-in-continuous-replication
or here:
https://xcp-ng.org/forum/topic/12031/backup-info-under-vm-tab-in-v6-never-loads...

[ph7]

I only saw 1
Enabled my disabled manual job
now I see all of them.

edit:
Clicked Home and then Backup Restore
and now I only see 1

[ph7]

I have 2 jobs enabled and 4 disabled in Backup Overview
The 4 disabled are enabled in Sequences

[ph7]

A CR job (1 of the 2 enabled) ran and now I see all of them again

[MathieuRA]

@Team-XO-Backend Someone can take a look at it? I won't be to much available this week

[acebmxer]

I posted in the original thread that this issue only exists in this test branch. When i switched back to master branch all restore points were visable.

Edit - Just updated to 875ce and now back to single vm listed for restore... Commit bfb0a05 did not have issue.

Edit 2 - Updated to a6c50 and restore points are back again.

[Bastien Nollet]

@MathieuRA

I'll have a look

[ph7]

@Bastien-Nollet
I don't know, played around with it a little bit, all seemed to work, so I updated to master a6c50 as @acebmxer did and it still seems OK, so maybe we can put this on hold for now and put the energy on something else