GPU Passthrough
-
@tjkreidl
I do have one iGPU & another RTX 4060. I was just confirming which option to use -
@gb.123 Ah, OK. then the more powerful GP is the RTX4060, right? If so, use it for the passthrough. Also, on some CPUs you have to do a BIOS setting to allow this to work, because of memory limitations, but only on probably much older systems, if I recall correctly.
-
Still struggling to make it work. Simple passthrough is 'hanging' the VM and the VM gets stuck at splash screen.
Trying to figure out what to do
Do you know if I need to put the card in attach pci or just select it in the gpu section or both ?
-
@gb.123 YOu are trying to do passthrough to a specific VM? I don't think that used to be supported, but maybe is now.
Are NVIDIA drivers installed on the VM, as needed?
Sorry, it's been a while since doing this so I'm digging back into my memory.
Also, is IOMMU supported and enabled in the BIOS?
Also, check this out and see if it may be of some help:
https://www.youtube.com/watch?v=_JPmxmxqhds -
Can you please confirm if I need to attach PCI AND select the GPU in the upper section or either should work ?
-
@gb.123 You need to do both. After adding the PCI device, you might also need to specifically enable "passthrough" for that device within the VM's settings. It may do it automatically when you add it.
Make sure the appropriate NVIDIA driver is also installed on the the VM. -
You are trying to do passthrough to a specific VM? I don't think that used to be supported, but maybe is now.
Yes. 1 Card -> 1 VM. Nvidia opened the passthrough lock in 2021. (Before that it was locked)
Are NVIDIA drivers installed on the VM, as needed?
I am installing them(tried the open one), but they are causing issues.
Also, is IOMMU supported and enabled in the BIOS?
Yes
-
@tjkreidl said in GPU Passthrough:
After adding the PCI device, you might also need to specifically enable "passthrough" for that device within the VM's settings. It may do it automatically when you add it.
This is one of my confusions. It is not automatically adding it. Whether I should select it or leave it blank is the confusion.
-
Once I install graphics drivers (nvidia) and allow pci passthrough of the graphics card, i get:
NVRM: cpuidInfoAMD Unrecognised AMD processor in cpuInfoAMDand the VM refuses to boot
If I remove the drivers or detach the card, then the VM boots
-
@gb.123 Are you sure you have the correct drivers installed? Also, check if the GPU is compatible with AMD CPUs -- I only had Intel CPUs, so am not sure if that's an issue or not.
-
Thanks so much for your response !
I agree with you that the drivers may be a problem. I am starting again from scratch and re-installing everything.
Though a question does remain that whether we need to use both options (Attach PCI + GPU Selection) or either option for GPU pass through. Maybe someone in @vates-tech-support can clarify exactly what the option in Xen Orchestra means.From what I know, the GPU option in the upper menu wasn't there a few version before. Seems to be a new entry.
-
@gb.123 I'm sure you can also find some NVIDIA "hoe to" guides that might be helpful. As mentioned before, I've only done server passthrough so that all VMs would get access,
so sorry I can't provide more specifics. You can always try with one or the other option and add the other if it still doesn't work. I'm pretty sure, though, that you do need both enabled.
Keep us posted!
