Hi i have a problem with warm migration
When i try migrate in XO from vmware i always for first try have communication like this:
"Can't import delta of a running VM without its parent vdi"
when i try again the migration starting but they shutdown the machine on vmware and do this offline
nothing change if i have mark "stop the source VM" or not

Hi
How can i set custom priviliage group
i see now admin, operator and viewer?
can i set some cutom group ? or add to operator snapshot create privliage?

@jbamford said in Create Bond for management:

@OskarNTT I’ve done it in XO.

without interface?

@jbamford Xo cant create BOND without interface so i cant create bond and vlan to move interface

@nikade said in Create Bond for management:

When creating a bond with XCP-NG center the mgmt interface is moved on top of bond0 and is the "untagged" vlan. So in cisco that would be the "native vlan".

There is a short interruption and then connectivity is back again if you've configured the switch in LACP-mode (if choosing lacp when creating the bond).

What if i have vlan and this is required?

@Tristis-Oris said in Create Bond for management:

@OskarNTT at that moment XO will lost connect to server and can't done creation.
Can you change mng to another link for that operation?

Not possible this requires from me changing in physicall inftstrature
eth0 and eth1 going to managment switch
eth2 and eth3 going to main lan
eth4 and eth5 going to backup vlans

and i create bond on lan and backup but cant on managment

edit:
Any tips, step by step how can i set this?

@Tristis-Oris cant create with interface when i have managment
on other my ethernet connection i have no problem, but create bond with eth0 when i have managment is a problem for XO. I wish maangment would use bond not only eth0

Hi
How can i set BOND to my eth0 and eth1 when i have management on eth0 with vlan ?

@Danp I want to know who, when and on what machine changing. Like create or delte snapshot. Change confgiuration like cpu, ram, disk (extend, add) and VIF (connect, disconnect, change vlan)
I need this becouse we are working in many teams with large group of peaople.

@Danp Ok if i have more then 2 hosts in pool how can easy check who is the master to set ip in the settings?
And another question, now i have master host number 2 but setting server have host number 1 and it works now

@lawrencesystems said in XO changed master pool after host down:

@OskarNTT

For HA to work properly you need 3 hosts.

https://xcp-ng.org/docs/ha.html#introduction

Only what i see is a strongly recommended, not required

Ok so another question
When i create snapshot, in audit log i have UUID VM an i can easily bind this task with that VM.
But when i delete snapshot i dont have UUID VM but only UUID deleted snap disk. How can i bind delete snapshot taks with specific VM ?

Hi I have a problem
I have pool with 2 hosts with enable HA and shared storage
when i shut down master host for test.
HA work properly and restart vm on another host also master change from host 1 to 2 , but XO dont see anythink. its empty, not detect new master.
When i power on host 1 the XO detected pool and both host and i see the master are change and vm works properly.
Why XO cant connect to the new master when first host is down?

Hi i have problem on XO.
When i go to Tasks tab i dont see any previous tasks.
If i wait some time newly generatly task are appear in prevoius task but when i refresh page, again i dont have any prevoius task.