XCP-ng 8.3 updates announcements and testing
-
Can also confirm that I was able to apply this round of patches using rolling update method without any issues or slowdowns on a pool of 5 hosts.
-
@gduperrey Restart happens normally, without any noticeable delay, but shutdown takes a long time. Which logs should I specifically check?
(It's not a real issue, but I just needed to move servers in the lab and had to shut them down, so I noticed it.)
-
@abudef After the excitement from the last update cycle (see my post above from ~January 29), I kicked off a Rolling Pool Reboot this time before considering a Rolling Pool Update. During this RPR, the first host is currently hanging on its shut down right now after about 10 - 15 minutes as shown in the screenshot. I am running the previous most recent version of XCP-ng, again from January 29, 2026. I'll revisit installing these most recent updates once I get clean reboots.
-
@robertblissitt Press ESC and you'll see what's happening
-
Normal for the pool master to take a bit longer but never seen 15 minutes before.
-
As explained, I haven't observed such a delay on our end during our testing.
As Maniix suggests, you can see what's happening by pressing "Esc" to see which step is taking longer.
From what I've heard internally, a common reason for this lengthy step is when a shared server was running on a VM and that VM was shut down. The host then takes a very long time to shut down or restart.
-
@gduperrey
In my homelab I've had the same problem for at least 18 month's
when shutting down theXO-VMit hangs for 2-3 minutes when it tries to umount the remotesumount /run/xo-server/mounts/xxxxx (SMB and NFS) umount /run/xo-server/mounts/yyyyy (SMB)I did report this in an earlier thread
-
@ph7 This I can confirm, with XO VM.
But discussion was about the host.... -
For XO, I suggest you start a separate thread.
Regarding the host issue, without more details or information, it's difficult to say anything at the moment, especially since I haven't been able to reproduce it myself.
-
@gduperrey Absolutely understand.
I didn't now about the Escape key as Manilx mentioned. Next time, I will press Esc to see if there is any useful information and report it here. This was just new behavior and wanted to report it informally. -
In my case, I gave the command to shut down all hosts, and the master "made it" first. The other hosts then got "stuck" at this point for a very long time:
-
@abudef In case of a shutdown, I turn off the secondary servers first. Once they are off, I shut down the primary server. This ensures that if the secondary servers have information to send to the primary, they can do so, whereas otherwise, they can wait to shut down.
In case of a pool reboot, I reboot the primary server first, and once it is accessible, I reboot the secondary servers.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login